Committee on Foreign Investment in the United States and the Directorate of Defense Trade Controls. Kuka said its takeover by Midea needed the approval of the U.S. regulators who objected to KUKA's sale to Chinese consumer products manufacturer Midea. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.KUKA sells KUKA AERO to comply with US objections of sale to Chinese MideaĪdvanced Integration Technology (AIT) will acquire KUKA Systems Aerospace North America (KUKA Aero), in a carve-out transaction to comply with U.S. The requirements listed below are representative of the knowledge, skill, and/or ability required. QUALIFICATIONS To perform this job successfully, an individual must be able to perform each essential duty satisfactorily.

Review drawing package for correct interface, verify that the interface matches application.ĮDUCATION and/or EXPERIENCE High school diploma or general education degree (GED) or one to three months related experience and/or training or equivalent combination of education and experience.Works along side with PLC debug group as a team.Provide all backup and documentation to Robot Leader after project is installed and running production.Conduct themselves during installation in the field as a KUKA representative.Adheres to the Quality System and participates in continuous improvement.Understands and follows safety and environmental regulations and identifies safety/environmental concerns.Document all broken robot equipment that has been replaced.Support FIS / Tech Review / 20 hr / 2500 cycle run.Document all changes to robot programs and End-Effector sequence changes.Make necessary changes to achieve cycle time.Run metal and Verify weld spot locations.Assist pipefitter / electrician with resolving robot dressing problems.More experienced programmers are able to debug auto repeat with PLC Programmer.Set up Software Limits to match hard stops.Debug programs in slow speed and verify all signal’s to and from the PLC.More experienced programmers are able to set up signals between Robot / PLC interface.Teach robot path programs: Weld, Material Handling, Maintenance, Tip Dress etc.Able to understand or Configure Robot D-Net / I/O Communication, based on level of experience.Willing to work overtime and weekends (50 hours)ĮSSENTIAL DUTIES AND RESPONSIBILITIES include the following.Willing to work at various KUKA locations in metro Detroit area, also support GM plants in Canada & Mexico.Vision experience and/or robotic engineering degree.We are looking for robot programmers of all experience levels.

Kuka clinton township